– 26 –
– 27 –
Radio-controlled projection alarm clock
B: Projection (Fig. 1):
B 1:
Symbol outdoor temperature
B 2:
Alarm symbol (if alarm is activated)
B 3:
Symbol indoor temperature
B 4:
Time/indoor temperature/outdoor temperature
C: Buttons (Fig. 2+3):
Top:
C 1:
SNOOZE/LIGHT
button
C 2:
Projection HIGH/LOW/OFF
button
Front:
C 3:
ALARM
button
C 4:
CALENDAR
button
Back:
C 5:
–
button
C 6:
SET
button
C 7:
+
button
D: Housing (Fig. 2):
D 1:
Battery compartment
D 2:
Power supply connection
D 3:
Projector arm
D 4:
ROTATE
dial
Transmitter
E: Display (Fig. 4):
E 1:
Channel 1,2,3
E 2:
Transmission signal
E 3:
Battery symbol for the transmitter
E 4:
Outdoor temperature
F: Housing (Fig. 4):
F 1:
Battery compartment
F 2:
Support for wall mounting or table standing
F 3:
Indentations for the holder for wall mounting
Radio-controlled projection alarm clock
G: Buttons in the battery compartment (Fig. 4):
G 1:
TX
button
G 2:
1 2 3
switch for channel selection
5. Getting started
5.1 Getting the transmitter started
• Place the base station and the transmitter on a table at a distance of about 1.5
meters from each other. Avoid being close to possible sources of interference such
as electronic devices and radio equipment.
• Open the battery compartment of the transmitter and insert two new AA 1.5 V bat-
teries, polarity as illustrated. All LCD segments will be displayed for a short
moment.
• The display shows the temperature. The switch is set to channel 1. Channel 2 + 3
are reserved for other models
• Close the battery compartment.
5.2 Getting the projection alarm clock started
• The projection alarm clock can be operated with 3 x 1,5 V AAA batteries (not
included). The batteries maintain the clock operation in the event of blackout or
other power failure. In pure battery operation, the backlight is briefly activated with
the
SNOOZE/LIGHT
button and the projection with the
Projection HIGH/LOW/OFF
button. For a permanent backlight and projection and to conserve battery power,
use the supplied power adapter.
• Fold out the projector arm. Insert the power adapter pin into the device jack and
connect the plug to a wall socket.
• The device is ready for use.
• The device will alert you with a beep and all LCD segments will be displayed for a
short moment.
• Optional: Open the battery compartment and insert three new AAA 1.5 V batteries,
polarity as illustrated. Close the battery compartment.
5.3 Reception of outdoor transmitter
• The base station will scan the outdoor temperature. “- -,-” appears on the outdoor
temperature display and the reception symbol flashes.
• If the reception is successful, the outdoor temperature and the reception symbol
appear steadily on the base station display.
• If the reception of outdoor temperature fails, check the batteries and try it again. If
no reception is possible, “NO” appears after three minutes.
• You can also start the transmitter search manually (e.g. if the transmitter signal is
lost or if the batteries are changed). Press and hold the
+
button on the base station
for two seconds. The reception symbol for the outdoor transmitter will be flashing.
TFA_No. 60.5018_Anl_09_22 21.09.2022 11:01 Uhr Seite 14
