TF TOP FLITE P-470 THUNDERBOLT, Руководство пользователя

Страница: 16 / 36

16
o
7 . Cut the included CA hinge material into six 3/4"
x 1" [19mm x 25mm] individual hinges . Use a hobby
knife or scissors to trim the corners from each hinge
to make them easier to insert into the hinge slots .
o
8 . Drill a 3/32" [2 .4mm] hole 1/2" [13mm] deep in
the center of each hinge slot in the wing panel and
aileron . Use a sharp hobby knife to carefully cut away
the covering just around each hinge slot .
o
9 . Insert three hinges into each elevator . If the
hinges don’t remain centered, stick a pin through the
middle of the hinge to hold it in position . Slide the
hinges into the elevator, sliding the joiner wire into the
hole in the elevator . Once you are satisfied everything
fits, remove the elevator .
o
10 . Apply a small amount of epoxy into the hole in
each elevator half . Re-install the elevators and hinges
to the stab . Remove any pins you may have inserted
into the hinges . Adjust the elevator so there is a small
gap between the LE of the elevator and the stab . The
gap should be small, just enough to see light through
or to slip a piece of paper through . Apply six drops of
thin CA to the top and bottom of each hinge . Do not
use CA accelerator . After the CA has fully hardened,
test the hinges by pulling on the elevator . Do this for
both elevator halves .