Textron Ransomes TMM48R, Инструкция для оператора

Страница: 20 / 30

18
ASSEMBLY OF MOWER TO TRACTOR
PREPARING THE TRACTOR
1 When optional large tires (AG5.00-12, AG6-12
with AG9 .5-16) are attached to the tractor, the
mower can not be mounted. Use standard
tires or turf tires only. The front wheel tread
setting in two wheel drive tractor should be
adjusted only as shown in Figure 23 when the
mower is mounted.
2. Set tractor lift links at the lift rods for full lift
height to prevent lift links from being too low
when mower is in operating position, Figure
20.
ATTACHING THE MOWER LIFT LINKS TO THE
TRACTOR
NOTE: Tighten all of mounting bolts and nuts with
the correct torque’s after all bolts are in place. See
bolt torque’s, page 14.
1. Install the front bracket to the inside of tractor
front support, Figure 12.
NOTE: If a loader bracket is installed, put it to the
out side of the tractor front support. These brackets
should be tightened together, Figure 13.
Figure 12 - Installing the Front Bracket without
Loader
Figure 13 - Installing Front Bracket
with Loader Mounting Bracket
2. Install the rear bracket below the transmission
housing, Figure 14.
Figure 14 - Installing the Rear Bracket
TRANSPORTING THE MOWER
WARNING: For safe operation, when
transporting the tractor using 3-point
hitch or loader with mower attach, the
mower must be locked in transport
position. Raise the mower and lock the
lift link using the hook and pin to the
rear bracket. Figure 15.
Figure 15 - Locking the Mower when transporting
PREPARING MOWER FOR OPERATION