Textron POWER FINDER CIRCUIT SEEKER GREENLEE 2011/00521, Инструкция по эксплуатации

Страница: 11 / 24

11
2011
Operation
(cont’d)
To use receptacle adapter, AC blade, and alligator clips:
1. Always connect to ground or neutral first when using the supplied accessories.
2. If connecting to a receptacle, attach the AC blade to the receptacle adapter. Otherwise,
attach one of the supplied alligator clips to the receptacle adapter.
3. Connect to ground or neutral, and then insert the AC blade into the receptacle or
connect to the conductor.
4. Plug the transmitter into the receptacle adapter.
5. Turn on the transmitter. The LEDs will flash simultaneously, indicating a good battery.
Next, only one LED will flash, indicating the line mode and that the transmitter is
working.
The Receiver
Turn the unit on by pushing the HIGH RANGE or LOW RANGE button. The corresponding LED
will light to show the unit is operating. Use the LOW RANGE setting anytime you can physi-
cally touch the receiver tip to the wire or breaker. For all other applications the HIGH RANGE
setting is typically used. It is important to note there is a distance overlap between high
and LOW RANGE settings. If you do not receive a signal on the LOW RANGE setting, simply
use the HIGH RANGE instead. If the receiver is too close to a line in the HIGH RANGE setting,
and it does not automatically turn gain down, then use the LOW RANGE setting. Select the
range desired and operate as discussed in the following instructions.
Note: This unit works best when held in your hand because your hand and body act as a
ground plane reference, which improves the sensitivity of the receiver. Without this ground
plane reference, the range of the receiver can be cut in half.