Textron Greenlee 915FS, Инструкция по эксплуатации

Страница: 20 / 52

915FS Splicer
Greenlee / A Textron Company
1390 Aspen Way • Vista, CA 92081 USA • 800-642-2155
20
Explanation of Splice Modes
(cont’d)
Mode No. Splice Mode Description
6 SM
For splicing standard single-mode fiber (ITU-T G652).
The MFD is 9 to 10 µm at wavelength of 1310 nm.
User can edit all parameters of this splice mode such as prefuse power, prefuse
time, arc power, arc time, align, proof test, etc.
The manual splicing operation is provided. Automatic arc calibration does not work
in this splice mode.
7 DS
For splicing dispersion-shifted fiber (ITU-T G653).
The MFD is 7 to 9 µm at wavelength near 1550 nm.
User can edit all parameters of this splice mode such as prefuse power, prefuse
time, arc power, arc time, align, proof test, etc.
The manual splicing operation is provided. Automatic arc calibration does not work
in this splice mode.
8 NZ
For splicing non-zero dispersion-shifted fiber (ITU-T G655).
The MFD is 9 to 10 µm at wavelength of 1550 nm.
User can edit all parameters of this splice mode such as prefuse power, prefuse
time, arc power, arc time, align, proof test, etc.
The manual splicing operation is provided. Automatic arc calibration does not work
in this splice mode.
9 MM1
For splicing multi-mode fiber (ITU-T G651). Core diameter: 50.0 to 62.5 µm.
User can edit all parameters of this splice mode such as prefuse power, prefuse
time, arc power, arc time, align, proof test, etc.
The manual splicing operation is provided. Automatic arc calibration does not work
in this mode.
10 AT1(SM)
User can set the attenuation value in the range of 0.1 to 15 dB.
Set the desired splice loss. If after the splice is completed the desired loss is not
achieved, the user can adjust the splicing coefficient. Increasing the coefficient will
increase the desired loss; decreasing the coefficient will reduce the splice loss.
11 SM FAST
For splicing standard single-mode fiber (ITU-T G652).
The MFD is 9 to 10 µm at wavelength of 1310 nm.
It is the fastest splice mode at 9 seconds splicing time. This mode process does
not analyze fiber geometry.
12 SM G657
For splicing standard single-mode fiber (BIF G657).
The MFD is 9 to 10 µm at wavelength of 1310 nm.
User can edit all parameters of this splice mode such as prefuse power, prefuse
time, arc power, arc time, align, proof test, etc.
13~60
BLANK
(other modes)
User can assign these as their own custom splicing profiles.