Textron 742105, Инструкция по установке, частям и обслуживанию

Страница: 6 / 58

4
JZT 1000
Series
ASSEMBLY AND SETUP
5. Roll the power unit up to the cutterdeck. Cut the
tie holding the PTO shaft together. Connect
the PTO shaft to the power unit gearbox with the
quick coupler. Line up the splines in the coupler
with those on the gearbox. Pull back on the
outside of the quick coupler to slide it on the
gearbox, then release. Pull back on the shaft to
seat the locking balls in the groove of the gearbox
shaft. When properly installed the PTO shaft
should not pull off the gearbox shaft. Push the
deck close to the power unit. On collection decks
guide the discharge chute into the blower inlet
opening.
6. Roll the deck carrier frame to the power unit.
Slide the receiver blocks over the power unit
push arm pins (3/4"-10x1/4"). Secure the carrier
frame with two (3/4 ID x1/4") thick washers and
a hairpin cotter, on each side.
4. Cut the wire tie holding the PTO shaft to the deck.
Rear Discharge Collection Decks Only;
Bolt the discharge chute to the rear of the
cutterdeck with (2) M6x16 carriage bolts, (2) M6
nylon locknuts and (2) washers. The head of the
carriage bolt should be inside the chute. Connect
the small spring between the bracket on the
discharge chute and the bracket on the cutterdeck.