Textron 742105, Инструкция по установке, частям и обслуживанию

Страница: 17 / 58

15
JZT 1000
Series
ADJUSTMENTS
PARKING BRAKE
Adjust the parking brake to provide 1/4” travel in each
cable before the slack is taken up.
To adjust:
1. Start with the brake in the
'OFF' position.
2. Remove the pin P holding the brake links to the
brake cable ends.
3. Reinstall the pin but only through the end of one
cable.
4. Move the brake lever toward the
'ON' position until
the slack in the cable is taken up, and resistance
from the brake spring begins to be felt.
5. Adjust the cable with jam nuts
J so there is
1/4”(6mm) of slack before the resistance of the
spring is felt.
6. Repeat for the other brake cable. When both
cables have been adjusted, reinstall the brake pin
through both cable ends and secure with the
hairpin cotter.
NOTE: If there isn’t enough adjustment at the brake
lever end of the cables, the drive wheels may be
removed and the cable adjusted at the mounting
bracket. Further adjustment may be obtained by
turning the bracket over.
Parking brake assembly - (brake in ON position).
Parking brake assembly - (brake in OFF position).