Textron 742105, Инструкция по установке, частям и обслуживанию

Страница: 7 / 58

5
JZT 1000
Series
ASSEMBLY AND SETUP
8. Locate the cutterdeck height of cut posts C under
the corresponding bushings of the cutterdeck
carrier frame. Use the handles on the cutterdeck
to lift the deck, guiding the height of cut posts into
their bushings. Secure each with a 3/4”(19mm)
I.D. washer and large hairpin cotter.
9. Set tire pressures down to 14 psi(.98kg/sq cm).
Tires are over inflated for shipping. Close
hydrostat release (dump) valves opened in Step
2, finger tight. Do not overtighten.
7. Have a helper lift the cutterdeck carrier frame as
high as it will go. Connect a counterbalance
spring from the carrier frame to the pin on the
tractor.
Final Preparations
a) Check the engine and hydraulic oil levels. Top
up with the correct oil if necessary. Use 10W30
motor oil for the engine. Use fresh clean
15W40 or 20W50 motor oil or 15W50 synthetic
motor oil for the hydraulic system.
b) Remove the battery from the machine. Fill the
battery to the bottom of the vent wells with acid
and trickle charge for several hours. Replace
the battery in the machine and make the
connections, red to positive first, then black to
negative. Close the hydrostat bypass valves.
c) Read Operation and Safety Manual before
starting.
d) Run engine at full RPM for 5 minutes before
engaging blades to allow the engine to be fully
lubricated.
e) Check the hydrostat neutral adjustments. Neutral
is set at the factory, but readjustment may be
required due to air trapped during the initial oil fill
working it way out of the system. See the
adjustment section in this manual.
d) Do not use the machine without an approved
grass collector, the grass discharge chute or
mulching plates correctly fitted.