Textron Specialized Vehicles TRACKER LX6 EFI, Руководство по ремонту и обслуживанию

Страница: 81 / 168

B
FUEL SYSTEM
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
63
Repair and Service Manual
699324
Fig. 3 Fuel Tank Connections
4. Disconnect the fuel line from the tank by pressing
the button on the fuel line connector while pulling the
connector away from the tank (See Fig. 3). Plug the
fuel line to prevent fuel leakage.
5. Disconnect the tube (12) to the carbon cannister.
6. Remove the forward hex nut (17), washers (18), and
bolt (16).
7. Remove the rear nut (17), washers (18) and spacer
(15).
8. Remove the tank from the engine compartment.
9. Installation is in reverse order of removal (Ref. Fig.
1).
10. Remove the fuel tank.
11. Installation is in reverse order of removal.
NOTICE: Make sure that the fuel line and vent line
are not kinked or restricted by wire ties, etc.
Fuel Pump Assembly
Tool List Qty.
Strap Wrench .............................................................. 1
NOTICE: The electric fuel pump, fuel filter, float and
fuel gauge sending unit are integrated into one
complete assembly (See Fig. 4). If any of these
components fail, the complete assembly must be
replaced.
1. Remove the fuel tank. See Fuel Tank Removal on
page 62.
2. Remove the pump assembly (3) by removing the
hold-down ring (6) and gasket (5) (See Fig. 4).
3. Pull the fuel pump assembly up and out of the fuel
tank.
4. With the fuel pump assembly removed, inspect the
hold-down ring seal (4) for damage. Replace as
necessary.
5. Installation is in the reverse order of disassembly.
Fig. 4 Fuel Pump
FUEL INJECTOR REMOVAL
Tool List Qty.
Socket, 5/16" ............................................................... 1
Socket, 10mm ............................................................. 1
Torx Bit, T21 ................................................................ 1
Ratchet ........................................................................ 1
Drip Pan ...................................................................... 1
1.
Disconnect the negative (-) battery cable.
2. Remove the air intake hose.
3. Remove the throttle guard.
4. Disconnect the wire terminal from the injector.
5. Remove the screw (14) that secures the fuel line to
the engine.
6. Disconnect the fuel line from the fuel injector. Use a
drip pan to catch any fuel that may leak from the fuel
line, dispose of the spent fuel properly.
7. Remove the bolt that secures the fuel injector to the
engine.
8. Remove the injector from the engine.
9. Installation is in reverse order of removal (Ref. Fig.
1).
Fuel Line
Fuel Pump
Wire
Fuel Line
Connector
Press button
to disconnect.
2
8
6
4