Textron Specialized Vehicles TRACKER LX6 EFI, Руководство по ремонту и обслуживанию

Страница: 21 / 168

B
GENERAL INFORMATION AND ROUTINE MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
3
Repair and Service Manual
699324
To operate neutral lock:
1.
Turn the key switch to the OFF position.
2. Place the direction selector in the R (reverse) posi-
tion.
3. Remove the seat.
4. Pull out (1) and rotate (2) the neutral lock pin handle
so that the pointed portion of the handle is over the
side of the direction selector cam.
5. Move the direction selector lever towards the area
between the F (forward) position and the R (reverse)
position. During that motion, the pin will snap into the
hole in the direction selector mounting bracket, pre-
venting any movement of the lever. When in this
position, the direction selector remains locked in the
neutral position.
Spring loaded mechanism. To pre-
vent possibility of fingers becoming
pinched in the direction selector
mechanism, hold direction selector lever when
releasing neutral lock pin handle.
Fig. 4 Neutral Lock
To activate the direction selector pull the neutral lock pin
handle out and rotate until the pointed portion of the han-
dle fits into the hole (3) in the direction selector cam.
ROUTINE MAINTENANCE
This vehicle will give years of satisfactory service, provid-
ing it receives regular maintenance. Refer to SCEDULED
MAINTENANCE CHART section for appropriate service
intervals.
NOTICE: Some maintenance items must be serviced
more frequently on vehicles used under severe driv-
ing conditions.
Periodic lubrication of the steering is recommended.
Do not use more than three pumps
of grease in each grease fitting at
any one time. Excess grease may
cause grease seals to fail or grease migration into
areas that could damage components.
Fig. 5 Lubrication Points
POWERTRAIN MAINTENANCE
Access the powertrain by raising or removing seat. Some
service procedures may require the vehicle be lifted.
Refer to LIFTING THE VEHICLE in the SAFETY section
for proper lifting procedure and safety information.
For maintenance procedures relating to the engine,
speed control, fuel system, transmission, rear axle, or
suspension, refer to that particular section in this manual.
See the TABLE OF CONTENTS for section location.
2
1
1
View from Underside of Vehicle
Rack
Ball
Joint