Textron Specialized Vehicles TRACKER LX6 EFI, Руководство по ремонту и обслуживанию, Страница: 145 / 168

B
WEATHER PROTECTION
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
127
Repair and Service Manual
699324
WEATHER PROTECTION
TOP AND WINDSHIELD
The top does not provide protection
from roll over or falling objects.
The windshield does not provide protection from
tree limbs or flying objects.
The top and windshield are designed for weather
protection only.
Clean with lots of water and a clean cloth. Minor
scratches may be removed using a commercial plastic
polish or Plexus plastic cleaner available from Service
Parts.
Transporting
To reduce the possibility of severe
injury or death while transporting
vehicle:
Secure the vehicle and contents.
Never ride on vehicle being transported.
Always remove windshield before transporting.
Maximum speed with sun top installed is 50 mph (80
kph).
If the vehicle is to be transported at highway speeds, the
sun top must be removed and the seat bottom secured.
When transporting vehicle below highway speeds, check
for tightness of hardware and cracks in sun top at mount-
ing points. Always remove windshield when transporting.
Always check that the vehicle and contents are ade-
quately secured before transporting. The rated capacity
of the trailer or truck must exceed the weight of the vehi-
cle (see GENERAL SPECIFICATIONS for vehicle weight)
and load. Lock the park brake and secure the vehicle
using ratchet tie downs.
SUN TOP
(REF FIG. 1)
Tool List Qty.
Plastic faced mallet ..................................................... 1
Wrench, 1/2"................................................................ 2
Wrench, 9/16".............................................................. 2
Rear Support Installation
Tap end caps (item 7) into top of the rear support (items 1
and 2) with plastic faced mallet (Ref Fig. 1) (See Detail
A).
At driver side, align holes in the rear support (item 1) with
holes in seat back support bracket, making sure that the
open end of support faces the front of vehicle as shown.
Insert bolts (item 3) through washers (item 4) and seat
back support bracket. Place nylon washers (item 5)
between seat back support bracket and rear support.
Secure with washers (item 4) and lock nuts (item 6) as
shown. Finger tighten hardware.
Repeat procedure with rear support (item 2) at passenger
side of vehicle.
Front Support Installation
Remove and discard four bolts from the front cowl (See
Detail B).
Place front support (item 8) on the ground in front of vehi-
cle.
On driver side, place lock washer (item 10) onto bolt (item
9) and insert bolt through bottom hole of front support and
two washers (item 12). Secure front support to vehicle at
lower hole in cowl. Repeat procedure on passenger side.
Finger tighten hardware.
Swing support up into position aligning upper holes.
Insert a spacer (item 11) between front support and upper
hole on each side of cowl. Secure with lock washer (item
10) and bolt (item 9). Finger tighten hardware.
Sun Top Installation
Position sun top (item 13) onto supports (See Detail C).
At front support, secure sun top loosely with bolts (item
14) and washers (item 15) from above with washers (item
16) and lock nuts (item 17) underneath . Finger tighten
hardware.
At driver side rear support, secure sun top loosely with
bolts (item 18) and washers (item 15) from above with
washers (item 16) and lock nuts (item 17) underneath
(See Detail D). Finger tighten hardware.
Repeat procedure on passenger side.
Tighten all hardware to 13 - 15 ft. lbs. (18 - 20 Nm) torque.