Texmo Industries Taro HCS SJ Series, Инструкция и руководство по эксплуатации

Страница: 30 / 41

Read this Operation Manual carefully before requesting repair. Contact the dealer from whom this equipment was
purchased. Servicing and troubleshooting must be handled by qualified persons with proper tools and equipment.
Common faults, root cause for these and suggested actions are provided in TABLE 2 below:
Fault Possible causes Suggested actions
Pump does not
run
No power supply Check incoming power supply and rectify
Motor tripping by TOP Allow the motor to cool
Very low voltage Operate in the recommended voltage range
Pump is jammed Dismantle the pump and clear the jammed parts
Capacitor failure Change the capacitor
Loose connections Check the connections
Pump has been kept idle for long
time Ensure free rotation of shaft by running the pump
for few minutes at least every alternate day
Pump does
not discharge
water
Foot valve leakage Change the faulty foot valve
Pump not primed Prime the pump
Air leakage on the suction side Check and correct for leakages
Foot valve exposed due to large
draw down / poor yield of bore Lower the foot valve and ensure that the foot valve
is always submerged after draw down.
Wait for water level to rise before pumping
Low-voltage operation Operate in the recommended voltage range
Pump shaft has sheared Replace the assembly rotor
11. Basic troubleshooting
Warning
To prevent serious accidents, disconnect the power supply before
inspecting the pump.
OMJP001A 30 2020.01