14
2 February, 2005 Code Sheet V4.01d (NZ1001)
[DISP]
[RESULT]
[CH_1]
to
CH_7
Use the
buttons to cycle
through the menu
[BREAK]
[BOTH]
[LEVEL]
Sets from 0 to –199999
[I-S+C]
[D+C]
[REG]
Sets from 0 to 999999
Select Reset Destination Register
Select Reset Trigger
Select Reset Mode
Select Reset Constant
Select Print Triggered by Setpoint
Select Log Triggered by Setpoint
Advanced Functions Mode – Set Up Register Reset and Setpoint Trigger Functions
From Page 12,
3rd digit [XX7]
Selecting any destination
register takes you to
Mode Reset
Selecting [OFF] in the Destination
Register Reset Setup takes you
to Setpoint Print Trigger Setup
Select [REG] to access the
source parameter to select the
number of the Modbus register
in the meter to be copied to the
reset destination register
XX
XX
Reset SPC to XX0
XX
Use the
buttons to cycle
through the menu
Programming Tip
If you do not require any
of the functions in this
mode, ensure it is set to:
Use the
buttons
to select a register as the
data source for the set-
point (111 to 16383)
Programming Tip
This mode can not be accessed if the
setpoint (SPC_1 to SPC_6) is in the
PID mode.
Select reset
trigger from
1 of 4 relay
operating
edges
Reset Trigger
Select register to be reset
Reset Destination Register
Select [Reg] in
reset mode
Reset Mode
Copy contents
of selected
register
SP1
to
SP6
Contents of
register copied into
reset destination
register
Reset Destination Mode
The reset destination mode allows you to select a reg-
ister to be reset using the contents of another register
triggered by a setpoint. See diagram below.
Reset Trigger
Select the reset trigger from 1 of 4 relay operating
modes.
Reset Destination Register
Select the register to be reset from the commonly
used register set 1 to 16383.
Reset Mode
1.
Select [REG].
2.
Contents of selected register copied into reset
destination register.
[TARE]
[RESULT]
[DISP]
The button takes you forward,
the button takes you back.
[VALY_1]
[PEAK_1]
[AUX_1]
to
[AUX_16]
Constant pressure on the
button
moves thru Registers 111 to 65536 one
register at a time.
Note, not all registers between 111 and
16383 are available.
Use the
and
buttons to cycle thru the
Registers Menu and
Registers (111 to
16383) to select the
data source for displays,
peak and valley, totaliz-
ers, and analog output.
Registers
[ 111]
to
[16383]
[TOT_1]
to
[TOT_7]
[CH_1] to [CH_7]
[VALY_2]
[PEAK_2]
[VALY_3]
[PEAK_3]
[VALY_1]
[PEAK_1]
[TOT_1]
to
[TOT_6]
[VALY_2]
[PEAK_2]
[VALY_3]
[PEAK_3]
[AUX_1]
to
[AUX_16]
Registers
[ 111]
to
[16383]
