Texmate, Inc. Tel. (760) 598-9899 • www.texmate.com
DL-40JANUS-SG manual (d0116)
Page 11
29
28 27
25
26
24 23 22
Options
4A
Order Code
OR12
OR14
-
4A
4A
4A
-
*R214
see note
SP2
SP4
SP1
SP3
9A
9A
9A
9A
9A
4A
4A
9A
SP3
SP1
SP4
SP2
Relay Modules with 2 Non-Isolated 4A Form A Relays,
and 2 Non-Isolated 9A Form C Relays
DL-40JANUS Series
Normally
Open
Normally
Close
29
28 27
25
26
24 23 22
Options
Order Code
OR52
OR54
-
-
210mA
210mA
210mA
210mA
210mA
210mA
SP4
SP3
SP2
SP1
SP4
SP3
SP2
SP1
Relay Modules with 4 Independent 400V
210mA DC only SSRs
DL-40JANUS Series
29
28 27
25
26
24 23 22
Options
Order Code
OR32
-
-
4A
4A
4A
4A
4A
4A
OR34
4A
4A
4A
4A
4A
4A
SP4
SP3
SP2
SP1
SP1
SP2
SP3
SP4
Relay Modules with 4 Isolated 4A Form A Relays
DL-40JANUS Series
*R234
see note
Normally
Open
Connector Pinouts continued
On board Relay Pins 8 to 11 and Relay Output Module Pins 22 to 29
Installation Guidelines
Installation
1. Install and wire meter per local applicable codes/reg-
ulations, the particular application, and good installation
practices.
2. Install meter in a location that does not exceed the
maximum operating temperature and that provides
good air circulation.
3. Separate input/output leads from power lines to
protect the meter from external noise. Input/output
leads should be routed as far away as possible from
contactors, control relays, transformers and other noisy
components. Shielding cables for input/output leads is
recommended with shield connection to earth ground
near the meter preferred.
4. A circuit breaker or disconnect switch is required to
disconnect power to the meter. The breaker/switch
should be in close proximity to the meter and marked as
the disconnecting device for the meter or meter circuit.
The circuit breaker or wall switch must be rated for the
applied voltage (e.g., 120VAC or 240VAC) and current
appropriate for the electrical application (e.g., 15A or
20A).
5. See
Case Dimensions section
for panel cutout infor-
mation.
6. See
Connector Pinouts section
for wiring.
7. Use 28-12 AWG wiring, minimum 90˚C (HH) tempera-
ture rating. Strip wire approximately 0.3 in. (7-8 mm).
8. Recommended torque on all terminal plug screws is
4.5 lb-in (0.51 N-m).
8
9
10 11
DL-40JANUS Series
SP2
SP1
Normally
Open
Isolated On Board 4A Form A Relays
Order Code
R2
SP1
SP2
4A
4A
*Note: If relays for setpoints 1 & 2 (R2)
are installed on the main board, and
a relay output module is used that
also has relays in the setpoints 1 &
2 (OR14 or OR34), the duplicate
relays will operate in unison.
