TEXIO GP-600B, Инструкция по эксплуатации

Страница: 30 / 49

24
It is possible to select CR.LF or CR.LF + EOI as the send delimiter
with the address switches on the rear panel.
Control Command List
Type Function name
Command
name
(Parameter)
Default
value
Common command
C
Resets the value to the
default.
*RST ---
Common command
C
Clears the status byte.
*CLS ---
Common command Q Reads the equipment ID. *IDN? ---
Data setting command 1
CQ
Sets a channel.
SELECT X1 ---
Data setting command 2
CQ
Sets a voltage/current mode.
MODE X1,X2 ---
Data setting command 3
CQ
Sets the voltage.
VOLT X1 ---
Data setting command 4 CQ Sets the current. AMP X1 ---
Data setting command 5 CQ Output control OUT X1 ---
Data setting command 6
CQ
Power relay control
POWER X1 ---
Data setting command 7
CQ
Sets SRQ masking.
MASK X1 1111111111
Data setting command 8 CQ Sets an output Off channel. OFFCH X1 1
Data setting command 9
CQ
Sets the maximum value of
the reference A.
MODEA X1 ---
Data setting command 10 CQ
Sets the maximum value of
the reference B.
MODEB X1 ---
Data setting command 11 CQ
Sets the maximum value of
the reference C.
MODEC X1 ---
Data setting command 12
CQ
Sets the maximum value of
the reference D.
MODED X1 ---
Data setting command 13
CQ
Sets the output value of
the reference A.
SETA X1 ---
Data setting command 14 CQ
Sets the output value of
the reference B.
SETB X1 ---
Data setting command 15
CQ
Sets the output value of
the reference C.
SETC X1 ---
Data setting command 16
CQ
Sets the output value of
the reference D.
SETD X1 ---
Data setting command 17
CQ
Sets the SRQ masking time.
MTIME X1 10
Data setting command 18 CQ Sets the listen-only mode. LISTEN X1 0
Data request command
CQ
Inquires about the status
data.
STATUS? ---
NOTES: 1. “C” means a command function and “Q” means a query
function in “Type” above.
2. “X1” and “X2” in commands are parameters.
(See the command list.)