Texecom Premier Elite ComWiFi, Руководство по установке, Страница: 14 / 32

Premier Elite ComWiFi Installation Manual
14 INS644

If you cannot find all of the required details on the router, simply follow the instructions to
automatically assign and IP address, and then disable DHCP and overtype the IP address with
the one you have chosen that is outside the DHCP pool.

In the web browser on a PC on the same network you should now be able to connect to the
ComWiFi with the new IP address you have given it. This will prove the settings have been
accepted.
5. Panel Settings Premier Elite
Now that the ComWiFi is enabled on the network, the control panel needs to be
configured to allow communication.
• Enter Engineer mode on the keypad.
• Press

then

/

( UDL/Digi Options ).
• Press

then

/

for ( Setup Modules ).
• Press

then

/

for ( Setup IP data ).
• Press

/

and enter the IP address of the ComWiFi you noted in the
previous steps. Pressing

/

when complete. Pressing the

/

key
twice will enter a dot. For Example 192.168.0.150
• Scroll down once to change the port number. This is required if you wish to
setup port forwarding through the router. The port can be left as 10001.
• Scroll down and enter the Gateway address assigned to the ComWiFi .
• Scroll down once and enter the subnet mask assigned to the ComWiFi
• Press

/

twice.
• Press

then

/

( Comport Setup ).
• Scroll to the comport you have the ComWiFi plugged onto.
• Press

/
 
and

/

for Com-IP module .
The settings will be sent to the ComWiFi . If you used DHCP to obtain the IP address,
this will now be disabled on the STA settings page of the ComWiFi to preserve the IP
address, and is the correct operation. After a minute the unit will be ready to use.
Exit engineers mode on the control panel.
The control panel can now be accessed on the LAN. However, to access the panel
from the
Texecom mobile apps or Wintex remotely , additional steps are required
within the various programmes and the control panel.