System Program Menus
Premier 412/816/832 Master User Manual
20
INS141-6
From
Previous Page
N
Text Editing Keys
1
2
3
4
5
6
7
8
. , ? ! 1 @ ” - &
a b c 2 A B C
d e f 3 D E F
g h I 4 G H I
j k l 5 J K L
m n o 7 M N O
p q r s 7 P Q R S
t u v 8 T U V
9
0
U
R
w x y z 9 W X Y Z
Space 0 , # *
Move Left/Right
Backspace (delete)
Use keys to enter/edit text.
Then press
to accept.
y
Premier 8SP
Banner Text
97
Premier 8SP
^anner Text
Press
n
to edit text.
Banner Text (LCD Only)
99
Exit Program Mode
98
Print 100 Events
Walk Test
("
The Walk Test feature can only be performed when the
partition is disarmed. 24 hour zones (except Fire, Tamper
and Trouble) are disabled during Zone Test allowing Audible
PA buttons, Silent PA buttons, etc. to be tested.
Test Speakers & Outputs
(#
This menu options allows you to perform the following tests:
#
Test Speakers
$
Test Bells
%
Test Strobes
&
Test System Outputs
"
When performing the “Test System Outputs” option,
only outputs programmed by your installer will be
activated during this test.
Send Test Call
($
This menu options allows you to send a test call
transmission to your Alarm Receiving Centre.
"
If the test call is unsuccessful, the keypad will sound
an error tone.
Enable Remote/Engineer Access
(%
Your alarm system may be configured in such a way that
you have to authorise Remote/Engineer Access. Once
authorised, your alarm system will allow:
•
Your installer/Alarm Receiving Centre to access the
alarm system via the remote downloading computer.
•
Your installer/engineer to access the control panel
programming menus.
The alarm system will allow access until 12.00am, after
which, both Remote and Engineer Access will be denied.
Start Call Back
(&
This option will cause the control panel to initiate a call back
sequence. This will allow the remote downloading computer
to remotely access the control panel.
"
You should only use this feature when requested by
your installer/Alarm Receiving Centre. If the Call Back
is unsuccessful the keypad will sound an error tone.
Program Time
('
The control panel has a real time clock that is used to date
and time stamp events that are recorded within the system
log. The option allows you to set the control panel time.
Program Date
()
The control panel has a real time clock that is used to date
and time stamp events that are recorded within the system
log. The option allows you to set the date on the control
panel.
Program Banner Text (LCD only)
(*,
If the system is fitted with a LCD remote keypad you can
assign up to 16 characters of text to the Banner Message.
The Banner Message is displayed on the top line of the LCD
display during the normal disarmed state. Text is
programmed in a similar way to mobile phones. Characters
are selected by pressing the corresponding key the
appropriate number of times (to select a character on the
same key, press
7
to move the cursor along). For details
on entering text, see page 14.
Print 100 Events
(!,
If your system has a printer connected, this menu option
allows the last 100 events in the system Event Log to be
sent to the printer.
Exit Program Mode
((,
Selecting this menu option will log you out of programming
mode and return the system to its normal state
