Premier 412/816/832 Master User Manual
User Functions Menu
INS141-6
11
3.
User Functions Menu
This section covers the more advanced functions that
selected users can perform with the alarm system. The
following functions are available:
Reset Alarms
This function is used to reset any standing alarms and
service faults. It is also used to reset detectors with a latched
alarm indication, e.g., Smoke Detectors.
"
To Reset Alarms, proceed as follows:
Premier 816
17:30.21 28/04
YES to Arm?
MENU for Options
The keypad will bleep and the alarm system will reset
all latching detectors and attempt to clear any standing
or
.
Alarms
Service Faults
Press
N0
Enter Access code
????
Press
R
Armed
Zones
8
7
6
5
4
3
2
1
Ready
Alarm
Service
Armed
Zones
8
7
6
5
4
3
2
1
Ready
Alarm
Service
1
2
3
Last Alarm Log
The control panel has a memory that stores the zones that
caused an alarm when the system was last armed.
"
To view the alarm memory, proceed as follows:
Last Alarm From:
Zone 03
YES to Arm?
MENU for Options
The keypad will display the zones that caused an alarm
when the system was last armed.
Press
to return to the normal disarmed state.
N
Press
N1
Enter Access code
????
Armed
Zones
8
7
6
5
4
3
2
1
Ready
Alarm
Service
1
2
3
Armed
Zones
8
7
6
5
4
3
2
1
Ready
Alarm
Service
Last Alarm From:
Zone 04
Service Faults
The response to a Service Fault condition is programmed by
the installer but is normally limited to the keypad buzzer. To
silence the Service Fault alarm, enter your Access code.
A flashing Service light indicates a new fault condition. The
alarm system cannot be armed whilst a new fault exists. The
Service light will remain flashing until the new fault is
acknowledged, after which it will revert to a steady yellow
and the alarm system can be armed. The Service light will
remain steady until all faults have been cleared.
AC Fail and Telephone Line Fault can each have a delay
programmed. The Service light will turn steady yellow
immediately on either of these faults but no Service Fault
Alarm (transmission or audible alarm) will occur unless the
delay expires.
"
If your installer has disabled AC fail acknowledgement
the Service light will flash “rapidly” during an AC fail
condition. The system can be armed without requiring
acknowledgement of this fault.
Acknowledging a New Service Fault
"
New service faults can be acknowledged as follows:
System Faults:-
Press Menu/Reset
YES to Arm?
MENU for Options
The keypad will display all Service Faults.
Press
or
to acknowledge the fault and return to
the normal disarmed state.
N
R
Press
N2
Enter Access code
????
1
2
3
Line Fault
Press Menu/Reset
Armed
Zones
8
7
6
5
4
3
2
1
Ready
Alarm
Service
Armed
Zones
8
7
6
5
4
3
2
1
Ready
Alarm
Service
View Service Faults
"
Standing faults can be viewed as follows:
1.
Press the
-
key followed by the
$
key.
2.
The keypad will display any Service Faults (see
tables on next page).
3.
On completion press the
-
key.
