Texas Snowbuster 1100E, Руководство пользователя

Страница: 11 / 22

11
CABLE ADJUSTMENT
Auger and traction cable
The auger and traction cable will need to be adjusted for proper traction and impeller loading.
Please follow the steps below.
Important:
The cables must in emergency situations, trigger the dead man lever, once the handles
are released.
Warning:
Do not engage the auger while adjusting the traction cable!
Warning:
Ensure that no people are around the machine during this adjustment!
1. Block up the Snowblower.
 This step will stop the machine from moving, if the cables are too tight.
2. Tighten the turnbuckle until there is no slack in the cables.
3. Start the engine once the cables are adjusted.
Traction adjustment
4. Pull the traction lever, the wheels should spin.
 If the wheels do not spin, tighten the cable even more using the turnbuckle
5. Release the traction lever, the wheels should immediately stop spinning.
 If the wheels still spin, release the tension in the cable using the turnbuckle.
Auger adjustment
6. Pull the auger lever, the auger should turn.
 If the auger does not turn, tighten the cable even more using the turnbuckle
7. Release the auger lever; this should immediately stop the auger from turning.
 If the auger turns, release the tension in the cable using the turnbuckle.
Emergency stop
Release both traction and auger lever at the same time, if proper adjusted the dead man levers
and shut off the engine switch.
If not; then readjust either the auger or the traction cable.
OPERATION ENGINE
Important!
You must fill up with engine oil and fuel before you can start the engine.
 Check the fuel and engine oil levels and top up it necessary
 Make sure that the spark plug cap is secured to the spark plug
 Clear and secure the work area
Starting the engine
1. Engine fuel valve
Turn the fuel valve to the ON position.
Fuel valve
On