Texas Razor Series, Руководство пользователя

Страница: 15 / 57

8
Mounting the recoil-starter: Illustration M4
1. Pull the engine brake handlebar and hold, in
order to release the starter cord on the engine.
2. Pull gently the starter cord from the engine
(Engine brake handlebar MUST be hold)
3. Attach the starter grip on the rack of
handlebar.
4. Release the engine brake handlebar and the
starter grip.
Mounting the breastplate: illustration M5*
1. For models with breastplate with cup holder
follow illustration M5-1
2. For models with breastplate follow illustration
M5-2
*Note: Not all models do have breastplate
Mounting the grass collector: Illustration M6
1. Click the frame to the grass collector.
The grass collector comes with a handy
indicator showing whether the box is full of
grass and needs emptying.
Rear discharge guard: Illustration M7-1
If you want to mow without grass collector it is important
to attach the two spacer blocks.
1. Insert the 2 blocks (ID:E) under the rear
discharge guard.
Note: The spacer blocks are for rear ejection only!
Otherwise they should be removed.
Warning: If the two blocks aren’t mounted. The
mower will have difficulties to dispose the grass.
Mulching plug: Illustration M7-2
1. Insert the mulching plug and remove side
discharge guard, if you want to mow with
mulching functionality.
NB Don’t use the grass collector
Important: Remember to remove the mulching plug,
when using the grass collector.
Side discharge guard: Illustration M7-3*
1. Lift the side guard and insert side discharge
guard. Then insert the mulching plug in rear
discharger to mow with side discharge
function. NB Don’t use the grass collector
*Note: Not all models do have side discharge guard
Cable Adjustment
The following cables may be necessary to readjust:
Illustration A1
1. Cable for drive
2. Cable for engine brake
3. Cable for throttle cable
Note: The choke cable cannot be adjusted!
Adjusting the drive cable: Illustration A1-1
If you experience slack in the drive cable, this can be
solved simply by tighten or loosen the bolt on the cable.
1. Tighten turning clockwise - loosen the cable.
2. Tighten turning anti clockwise - tighten the
cable.
Adjusting the engine brake cable: Illustration A1-2
If you experience slack in engine brake cable, this can
be solved simply by tighten or loosen the bolt on the
engine block.
Adjusting the throttle cable: Illustration A1-3
If you experience slack in revolution cable, this can be
solved simply by tighten or loosen the bolt on the
engine block.
Battery (Electric starter)*
Charge the battery before use
Before the electric start function is used, the battery
must be charged for 5 hours. Put the charger plug into
the hole in the battery and connect the charger to a
power supply. See illustration. A4
Charging during the season
The battery is charged a little during use, buy it will
likely be necessary to charge the battery a couple of
times during the season - depending if the number of
start/stops of the engine. Put it for charging for around 5
hours.
Storage of battery
The battery must always be stored dry and warm during
the winter. Never expose it for low temperatures.
Charge the battery completely before storing and then
place the lawn mower in a place where it is not exposed
to frost. Alternatively cover the battery with a thick
carpet or similar, If the mower is in a shed/garage
where there may be cold.
Charge battery 1-2 times during the winter to make sure
the battery keeps it full capacity.
Incorrect storage can damage the battery, and is not
covered by warranty.
*Note: Not all models do have Electric starter