Texas Instruments TAS2563, Руководство пользователя

Страница: 3 / 25

www.ti.com
Software
3 SLAU800 – January 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
TAS2563YBGEVM-DC Evaluation module
NOTE: PPC3-EVM-MB supports a VBAT range from 4.5 to 26 V. To apply a VBAT supply in the
range of 2.7 to 4.5 V, it is highly recommended to remove Jumpers J1 and J10 and to apply
this voltage directly to pin 2 of the respective header while simultaneously powering PPC3-
EVM-MB with 5 V. Otherwise it is possible that on-board supplies may collapse.
4 Software
The TAS2563 can be easily configured with PPC3 running the TAS2563 plug-in. To request access to the
software first request a myTI.com account
here .
After creating an account, navigate to the TAS2563 product page and follow the link in the information box
to request access to the software.
Figure 1. Requesting PPC3 Access
5 Device Configuration
The default configuration for the TAS2563 is described below in Table 2 and Figure 2 .
5.1 Default Jumper Settings
Table 2. Default Jumper Settings
Jumper Setting Description
J3 Remove Output 2 Sense
J11 Remove Output 1 Sense
J16 Insert EEPROM Write Protect
J18 I2C Control Select
J17 0x9A Ch 2 Address Select
J4 Insert VDD 2
J5 Insert IOVDD 2
J1 Insert VBAT 2
J9 - Data Remove PDM Data 2
J9 - CLK Remove PDM Clock 2
J8 - 2 Insert GPIO Select 2
J19 0x98 Ch 1 Address Select
J12 Insert VDD 1
J13 Insert IOVDD 1
J10 Insert VBAT 1
J15 - Data Remove PDM Data 1
J15 - CLK Remove PDM Clock 1
J8 -1 Insert GPIO Select 1