FPC401 EVM GUI Description and Setup
14
SNLU222B – December 2016 – Revised September 2019
Copyright © 2016–2019, Texas Instruments Incorporated
FPC401 and FPC402 Evaluation Module (EVM) User’s Guide
2.9
Data-Driven Interrupt Configuration
To configure data-driven interrupts, select the
Data-Driven Interrupt Settings
tab. The FPC is able to
monitor up to four bytes per port, and the monitored byte index is controlled by the
Byte Number
input.
Select the port number, register address to be monitored and the bits to be monitored and click
SET
. Note
that the monitored register address must be within the prefetched range for the selected port. Click
CHECK / CLEAR DATA
to determine which bits of the four monitored bytes triggered the interrupt. This
will also clear the interrupt.
Figure 16. FPC401 GUI – Data-Driven Interrupt Control
