Texas Instruments CDT370, Руководство пользователя

Страница: 47 / 83

Action Selection
4-3 Programming
4.2 Action Selection
Once the address ranges convenient for the application are selected, the
Select Action dialog box is opened as shown in Figure 4–2.
Figure 4–2. Select Action Dialog Box
DEVICE PROGRAMMING
Data EEPROM start address : 0x1F00
Data EEPROM end address : 0x1FFF
Program EPROM start address : 0x6000
Program EPROM end address : 0x7FFF
Select Action
<<Program>>
<Cancel>
<Blanck Check>
<Verify>
<Upload>
Warning:
1) Disconnect emulation cable from target system
2) Ensure target switches are set to ’EMU’ & install device in socket
3) Set all 3 switches on target connector to ’PROG’
You can select one of following actions:
-
Program to program the device
-
Blank Check to check that the device has no program
-
Verify to check the contents of the device against the CDT’s content
-
Upload to upload the contents of the device into the CDT’s memory
Program is the default selection. The action selected will be applied to the
memory address ranges selected previously.
Program
This action programs the contents of the CDT370 RAM into the device (byte
per byte copy, at the same addresses). The program is automatically verified.
Blank Check
This action checks whether a device has already been programmed or not.
Each EPROM or EEPROM memory location is compared to FFh.
Verify
This action verifies that the contents of the device memory perfectly match the
contents of the CDT370 RAM.
Upload
This action loads the contents of the device memory into the CDT370 RAM.