9.2
Setting Up the ADS1278EVM-PDK
J13
POWER
SUPPLY
CONFIG
S4
BOOT MODE SWITCH
J12
WALL SUPPLY CONNECTION
CONNECT IF NEEDED.
SEE TEXT.
www.ti.com
ADS1278EVM-PDK Kit Operation
The ADS1278EVM-PDK contains both the ADS1278EVM and the MMB0 motherboard; however, the
devices are shipped unconnected. Follow these steps to set up the ADS1278EVM-PDK:
Step 1.
Unpack the ADS1278EVM-PDK kit.
Step 2.
Set the jumpers and switches on the MMB0 as shown in
.
•
Set the Boot Mode switch to USB.
•
C5V and +5VA on jumper block J13 (if +5V is supplied from J14 +5VA).
•
Leave +5V and +VA disconnected on jumper block J13.
•
If the PDK will be powered from an AC adapter, connect J12. If the PDK will be powered through
the terminal block, disconnect J12. (See
for details on connecting the power supply.)
Figure 8. MMB0 Initial Setup
SBAU129C – November 2007 – Revised July 2008
ADS1178EVM, ADS1278EVM, ADS1178EVM-PDK, and ADS1278EVM-PDK
15