• IP 42 CR
9
Antennas
Danger
Danger of lightning striking!
If you use outside or roof antennae, it is vital
that you ensure the antenna unit is protected
adequately against lightning .
FM/VHF antenna
The antenna for receiving FM/VHF stations is connected
to jack
17
"FM" . This antenna can be a roof/outdoor an-
tenna or a cable TV connection . To connect the antenna,
you will need a coaxial cable .
If there is no antenna connection pro-
vided at the setup location, you can
use the wire antenna
d
supplied with
the unit . Unwind the wire antenna,
push the plug onto the pin in jack
17
"FM" and move the wire antenna
around to find the position where
reception is best . Then fix the antenna
in this position with adhesive tape .
To operate the remote control, you need two 1 .5 volt
batteries of type Micro or AAA (included in the scope of
delivery) .
Inserting batteries
• Slide the lid of the battery
compartment on the back of
the remote control open by
pushing it in the direction of
the arrow, and remove the lid .
• Where applicable, remove the
old batteries (please follow the
instructions on page 12) .
• Insert the batteries in the bat-
tery compartment as shown in
the figure .
• Replace the lid on the com-
partment and slide it shut .
AM/MW antenna
Antenna
c
supplied with the unit is for the reception of
medium wave stations (AM/MW) . You can set up this
antenna free-standing or screw it to a cupboard or wall
shelving .
Connect the connecting cable of the antenna to jacks
18
"AM" on the back of the CD receiver . Press the lever of
each connector terminal and insert the end of the cable
into the adjacent opening . When you release the lever,
the cable is clamped in position .
Mains connection
• Check that the mains switch
24
"Power" on the back of
the unit is turned off (position "OFF") .
• Plug mains cable
23
into a mains socket .
Remote control
Mode of operation
The remote control transmits the control signals by means
of infrared light . To allow this, you need to point the
remote control towards the unit . Ensure that the infrared
light beam is not obstructed by objects between the
remote control and the unit .
Fluorescent lamps and energy-saving lamps installed in
the vicinity can impair the function of the remote control
or even prevent it functioning .
