15
14
On the job ...
Application information: Reading the memory
Connect your PC to the data logger via interface and
start the program.
Activate the instrument driver by clicking with the right
mouse key on the testostor 171 icon and select OPEN.
The logger appears with its serial number
and the saved protocol.
Select the protocol and drag it to the main memory by
keeping the right mouse button pressed or click with the
right mouse button on the protocol symbol to read out a
section.
You can get information about the data of your
measurement protocol (
→
Page 26,
M
EMORY
CONTENT
).
On the job ...
Application information: Programming the logger
Connect your PC to data logger via interface and start
the program.
Activate the instrument driver by clicking with the right
mouse button on the testostor 171 icon and select
INSTRUMENT SELECTION.
If communication between the PC and the data
logger has been successful, the window opposite
appears with the status information of the data
logger which is to be read out...
Write a new
M
EASURING PROGRAM
(
→
Page 24,
M
EASURING PROGRAM
) or open one which is already
available (
→
Page 29,
O
PEN PROGRAM
). The program
saved in the logger is the first to appear in the selection
window.
Do you wish measurements or limit deviations to be
indicated audibly during a measurement series?
Is it required that D
EW POINT
and A
BSOLUTE HUMIDITY
are
also measured (
→
Page 27,
O
PTIONS
)
?
Does the (humidity) data logger have to be calibrated
(
→
Page 17,
O
N THE JOB
...
)?
Do you wish to change the temperature unit to °F (° C)
(
→
Page 28,
U
NITS
)?
Is the given
Date
and
Time
correct
(
→
Page 28,
S
YNCHRONIZE
)?
Pass on the programming to the data logger via
P
ROGRAM LOGGER
(
→
Page 26).
Save the programming for later e.g. on your hard disk (
→
Page 29,
S
AVE PROGRAM
).