Note: If a falcon wing door detects an obstacle
while closing, it reverses a few inches before it
stops moving.
Warning: Whenever a front door is
partially open (approximately 20°) as you
are opening or closing the associated
falcon wing door, you MUST keep your
hands (or any object) away from the
opening edge of the front door. When a
falcon wing door passes by a partially
opened front door, the distance between
the two doors is very narrow. Objects,
such as hands or fingers, placed in this
area, are not detected by sensors and can
therefore become pinched between the
doors. To avoid bodily injury, it is a good
practice to keep your hands away from
the front door whenever you are opening
or closing a falcon wing door.
Warning: When opening or closing a
falcon wing door, it is important to
proactively monitor the movement of the
door to ensure that it does not come into
contact with a person or object. Failure to
do so can cause serious damage or injury.
Caution: Remove accumulation of snow
or ice before opening a falcon wing door.
Snow can get inside Model X and ice can
prevent the door from opening.
Caution: In rainy weather, leaving a falcon
wing open while opening the liftgate can
result in rain water falling from the liftgate
into the rear seating area.
Note: Falcon wing doors open only when
Model X is stationary.
Obstacle Detection
A falcon wing door stops moving when one of
its many sensors detects an obstacle, or when
the door senses resistance because it has
made contact with an object. The touchscreen
displays a warning. In these cases, provided it
is appropriate to continue opening or closing
the falcon wing door, you can override
obstacle detection by pressing and holding
the switch located on the door pillar, or
touching and holding the associated door icon
on the touchscreen.
When Model X detects a low ceiling (for
example, in a garage), it opens the falcon wing
doors (and trunk) to a lower height, even if no
obstacle is detected. You can override this
height and open the doors higher by touching
the associated door icon on the touchscreen
(Controls > Quick Controls). The touchscreen
displays a message asking you if you always
want to open the doors to the higher height at
this location, and saves your choice. The next
time you open the falcon wing doors at this
location, Model X opens them to the height
you saved.
Warning: Before overriding a falcon wing
door's default opening height, visually
inspect the area to ensure adequate
clearance between the door and the
detected object.
Warning: Applying adhesive products
such as wraps, stickers, rubber coating,
etc. on the outside of the falcon wing
doors can affect the sensors’ ability to
detect obstacles properly.
Calibration
If the falcon wing doors lose calibration, a
message displays on the touchscreen. To
calibrate the doors, first ensure that both
doors have plenty of space to open and close
and are clear of passengers, objects, etc. Then
press and hold the Calibrate button until five
seconds after calibration is complete. During
calibration, the lower door opens all the way
out (requiring extra space on the side of
Model X), the upper door moves all the way
down, and then the lower door closes.
Interior Locking and Unlocking
From inside Model X, you can use the
touchscreen to lock or unlock doors and
trunks, provided a valid key is inside the
vehicle. Touch the lock icon on the
touchscreen's status bar.
Keys and Doors
Opening and Closing
11
