TESA TWIN-SURF, Инструкция по эксплуатации

Страница: 7 / 42

Instruction Manual for TESA TWIN-SURF
7
2.5 Main functions Codes
By selecting this menu, you can save the results of your measurements in the instrument's
memory. The status of the memory can be viewed by means of a filling bar in the code menu
of the instrument.
Position
By selecting this menu it is possible to see the current Z position of the touch probe. There is
both an indicator showing its position within the available range and the value expressed in
μm.
Measurement set
By selecting this menu, it is possible to set the measurement parameters such as the
standard, the number of cut-offs, the length of the cut-off, a variable delay between the
moment the power button/start measurement is pressed and the actual start of the
measurement. It is also possible to choose between automatic and manual return.
Parameters
Selecting this item allows you to choose which roughness values to display at the end of the
measurement (by default only Ra is displayed).
Calibration
Selecting this menu allows the instrument to be calibrated using the roughness setting
standard supplied with the TESA TWIN-SURF roughness gauge.
System
Selecting this menu item allows you to perform three functions:
•
Activate and deactivate Bluetooth
®
(only for the Bluetooth
®
version)
•
Change the language from English, French, German and Italian
•
Activate the reprogramming mode in order to reprogram the instrument, update the
firmware. Reprogramming process only possible through TESA DATA-STUDIO
software
2.6 Transversal
measurement
The probe holder permits the probe to swivel through 90° for inspecting a groove to depth.
The transversal measurement allows to reach surface not accessible in the standard axis.
For the probe swivel, please follow the procedure:
1. Unscew two screws to remove
the probe protection
2. Remove the probe by pulling out