11
/
49
All commands are not case-sensitive.
All log related command must specify the serial port. If the serial port is not
specified, then the command is applied to current port.
If the commands are executed successfully, the board returns ok. Otherwise,
returns an error message.
Some commands, listed in the following table, configure can be shown with
command ‘log command’, for example, you can input
Log ecutoff
to show the ecutoff configure.
dgpstxid
ecutoff
fix
interfacemode
logfile
posave
rtktimeout
rtksource
serialconfig
undulation
2.2
Command Reference
2.2.1
ANTENNAMODE
This command is used to configuration which signals will be tracked by the primary
and secondary antennas, respectively. It’s valid only for the receivers supporting dual
antennas, including BX316, BX316R and BX316D.
The command will not work immediately after it’s inputted. Follow the following
steps:
Input ANTENNAMODE command to choose the mode.
Input SAVECONFIG
Power cycle the board or input RESET commands.
Table 3 Antennamode
Name
Value