Mounting with bracket
This mounting method has the advantage of not requiring screws to attach the controller
to the instrument body. Before attaching the bracket to the instrument, mount the bracket
to the controller as shown with two screws.
Apply the felt cushion to the bracket to prevent scratching the instrument's finish.
Now you can attach the bracket to the instrument with the strap button. Loosen the strap
button of the instrument by unscrewing it a couple of turns and insert the slot of the brack-
et under the button. Tighten the screw to secure the bracket to the body.
CAUTION!
The screw of the strap button can loosen due to repeated removal and tighten-
ing or strong pressure on the bracket.
Mounting with screws and/or adhesive strips/pads
Marking and drilling the screw hole for the controller
Hold the controller in the planned position and mark the center of the hole to be drilled (in
front of the socket for the multi-pin cable) in the instrument body with a sharp pencil or
other suitable tool. Set the controller aside and using the greatest care, drill a 2 mm dia.
and 10 mm deep hole at the marked point.
Note:
If your guitar is an acoustic or semi-acoustic instrument with a top unsuitable for
drilling, or if you break out in a sweat already at the thought of mistreating your instrument
in such a manner, then you can also install the controller with double-sided adhesive
strips or Velcro. Screw mounting is the most secure, however, and we recommend it whe-
rever possible.
AXON PU 100 (English)
9
