1.
Remove the protective backing from one side of the adhesive strip/pad and apply it to
the underside of the controller.
2.
Clean the mounting surface of the guitar thoroughly to ensure that the adhesion is not
affected by dust, dirt or grease.
3.
Remove the remaining protective backing from the adhesive strip/pads on the control-
ler and place it on the guitar body in such a way that the screw hole in the guitar (if
drilled) is aligned with the hole in the controller.
4.
Press the controller firmly – but carefully – into place to ensure proper adhesion.
5.
Finally, insert the self-tapping screw (3x6 mm) through the hole in the controller and
into the hole previously drilled in the instrument. Ensure that the screw is only finger-
tight. Over tightening the screw can damage the controller or the instrument.
Note:
The controller can be attached to practically any body type using the adhesive strips
or pads.
Adhesives may react chemically with some instrument finishes, resulting in discolora-
tion or other damage. If in doubt, apply a small piece of adhesive strip/pad in an in-
conspicuous location for several days to determine whether they affect the finish of the
instrument.
If your instrument has a curved top or the installation location is shaped in such a way
that the controller cannot be attached using adhesive strips alone, apply spacers to
compensate for the uneven surface. Like the strips, the spacers also have adhesive
on both sides which is protected by backing paper.
Mounting with Velcro
1.
Cut the Velcro strips, which are attached to one another, into three sections and apply
them to the underside of the controller.
2.
Remove the protective backing from the other side of the Velcro strips and attach the
controller to the guitar body.
3.
The controller can now be gently pulled off and reattached to the body as needed.
Note:
This is not the most secure mounting method and should only be used if no other op-
tion is suitable, or if the pickup will be used often on different instruments.
10
AXON PU 100 (English)
