581-504 4 ½” OD Single Post 4 Seat Swing
GENERAL USE/FALL ZONE & FOOTING RECOMMENDATIONS
SINGLE AXIS SWINGS:
The Use/Fall Zone should extend to the front & rear, a minimum distance of twice the
height of the Top Rail above the resilient surfacing material. The Use/Fall Zone to the
sides should follow the general recommendation of six feet minimum. This six-foot zone
may overlap that of an adjacent swing structure.
ROTATING SWINGS:
The Use/Fall Zone should extend in all directions the length of the swing plus six feet.
The six-foot minimum fall zone from the supporting structure also applies, and may
overlap the six-foot zone of an adjacent swing structure.
GENERAL MAINTENANCE INSTRUCTIONS:
Check MONTHLY for loose bolts, damaged or broken parts. Tighten and/or replace
immediately. On swings and any equipment that uses S-Hooks and/or Swing Hangers check
the bearing surfaces for wear. Replace any parts that show a reduction of 25% from the
original size.
SPECIFIC ASSEMBLY INSTRUCTIONS:
STEP #1:
Assemble swing frame on side on ground. If more than one section, assemble
section by section. Lay out parts so that when frame is erected, legs will
be in approximately the correct position.
