23
ATTENTION! Don’t use constrained air-feeding in the ash drawer.
To reduce the amount of pollutant emissions it is necessary to start the ignition from the upper part of
the fuel and during the use of the stove add firewood into the fire chamber by small portions.
Fire box shall be filled with small and medium firewood for quick achievement of high temperature in
a steam room with more economic expense of firewood (regime of temperature increase). Large-size
firewood shall be put into the bottom and smaller ones to the top. Put the kindling wood on top of the
firewood.
Ash hole shall be closed and big firewood shall be loaded into the combustor for supporting of stones’
temperature and air in a steam room. Sensible quantity of firewood is 3-4 pcs.
For the emergence of a stable chimney draft after heating of the stove is needed a little time. Small
smoke emission in a premise is possible if would be opened the door of the just heated working in the
regime of temperature increasing stove. Burning of the first fuel is sufficient for flue preheat and
developing of a chimney draft which prevents fuming.
In the following, air flow, affecting the combustion rate, would be regulated with opening or closing
of the ash drawer.
For laying a regular batch of fuel, it is necessary completely close the ash drawer and to slowly open
the door after some seconds.
Be careful during the regular firewood adding to not put out the fire.
For ending of the stove’s operation, please, wait till completely burning-out of a fuel, thereafter,
clearing the stove from ash and to close fully the door, the ash drawer and the gate.
ATTENTION! Don’t extinguish fire with water.
ATTENTION! Little deformation of metal is possible in the combustor at the time of
stove’s operation. It doesn’t disturb of hermiticity of weld seams. It isn’t a sign of
defective products.
ATTENTION! If temperature in a premise is less than +5°C at the period of pause in the
stove’s work, then water will be drained from a system of water heating.
8.13. Characteristic faults and methods of elimination
Trouble type
Possible cause
Troubleshooting
Disturbance of a burning process Chimney draft has deteriorated
Clean the chimney
Emergence of fuming
Chimney draft has deteriorated
Clean the chimney
Emergence of smell
Evaporation of remains of oils
and volatile components of
enamel
Preheat the stove in accordance
with point 8.2. in a place of
installation with maximum
ventilation of a premise
Drops on an external surface of a
tube
Insufficient impermeability of
joints of chimney
Densify joints with heat-proof
sealant
Slow heating of a premise
Insufficient heat insulation of a
premise
Incorrectly selected stove
Insulate a premise
Select a stove of higher power
Burnout of the fire bar and (or)
side walls
Have used a fuel with high
burning temperature
Overheating of the stove
Repair or replace the stove,
thereafter, use recommended fuel
