17
TELELIFT 3713 SX
SCHEDULED MAINTENANCE INSPECTIONS
4
17
Document 57.4402.9200 - 1
st
Edition 10/2006
INDEX
A-16 CHECK THE EFFICIENCY OF THE
STEERING SELECTION SYSTEM
During operation, the alignment of the front and rear
axles of the machine can be subject to variations. This
can depend on an oil blow-by from the steering control
circuit, or on a steering of both axles when front and rear
wheels are not perfectly aligned.
To fix this problem, rather than checking the alignment
visually, follow the procedure below:
1 Move to a solid and level ground.
2 Set the steering selection switch
A to
“four-wheel
steer” (pos.
).
3 Rotate the steering up to its stop (either to the right
or to the left).
4 Set the steering selection switch to “two-wheel steer”
(pos.
0
).
5 Rotate the steering up to its stop (turn in the same
direction as above).
6 Reset the steering selection switch to “four-wheel
steer”
(pos.
).
7 Rotate the steering (to the side opposite to point
)
so that the rear axle reaches its stop.
8
Reset the steering selection switch to “two-wheel
steer” (pos.
0
).
9 Rotate the steering (to the same side as in point
7
)
so that the front axle reaches its stop.
10 Reset the steering selection switch to “four-wheel
steer”
(pos.
).
Now the wheels should be re-aligned.
1
0
A
Содержание Telelift 3713 SX
Страница 4: ...Courtesy of Crane Market...
Страница 200: ...6 6 INDEX TELELIFT 3713 SX SCHEMATICS Document 57 4402 9200 1st Edition 10 2006 Y21 Y20 Courtesy of Crane Market...
Страница 202: ...6 8 INDEX TELELIFT 3713 SX SCHEMATICS Document 57 4402 9200 1st Edition 10 2006 Y01 Y02 B56 Courtesy of Crane Market...
Страница 205: ...6 41 INDEX TELELIFT 3713 SX SCHEMATICS Document 57 4402 9200 1st Edition 10 2006 22 23 30 32 31 Courtesy of Crane Market...
