Terex Genie Z-45XC, Руководство оператора

Страница: 48 / 60

Operator's Manual First Edition • First Printing
Operating Instructions
46 Z
®
-45 XC
™
Part No. 1301594GT
Drive Enable
Light on indicates that the boom
has moved just past either
non-steer wheel and the drive
function has been interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off
center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Drive Speed Select

Machine on incline symbol: Low range
operation for inclines

Machine on level surface symbol: High range
operation for maximum drive speed
Engine Idle Select (rpm)
To select engine idle (rpm), move the switch to the
turtle symbol or the rabbit symbol.
When the foot switch is not pressed, the engine
will idle at the lowest rpm.

Turtle symbol: Foot
switch activated low idle

Rabbit symbol: Foot
switch activated high idle
Generator (if equipped)
To start the generator, move
the generator toggle switch to
the on position.
Plug a power tool into the
power to platform GFCI outlet.
To turn off the generator, move the generator
toggle switch to the off position.
Note: Machine functions will not operate while the
generator is running and the foot switch is not
pressed down. When the foot switch is pressed
down, the generator will turn off and the machine
functions will operate.
Machine Not Level Indicator Light
If the tilt alarm sounds when the
platform is raised, the Machine Not
Level indicator light will come on
and the drive function in one or
both directions will not operate.
Identify the condition of the boom
on the slope as shown below.
Follow the steps to lower the boom
before moving to a firm, level
surface. Do not rotate the boom
while lowering.
If the tilt alarm sounds with
the platform uphill:
1 Lower the primary boom.
2 Lower the secondary
boom.
3 Retract the primary
boom.
If the tilt alarm sounds with
the platform downhill:
1 Retract the primary
boom.
2 Lower the secondary
boom.
3 Lower the primary boom.