First Edition • First Printing
Operator's Manual
Operating
Instructions
Part No. 1301594GT
Z
®
-45 XC
™
45
To Drive
1
Press down the foot switch.
2
Increase speed: Slowly move the control
handle off center.
Decrease speed: Slowly move the control
handle toward center.
Stop: Return the control handle to center or
release the function enable switch.
Use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Machine travel speed is restricted when the boom
is raised.
Driving on a slope
Determine the uphill, downhill and side slope
ratings for the machine and determine the slope
grade.
Maximum slope rating, platform
downhill (gradeability):
4WD: 45% (24°)
Maximum slope rating, platform
uphill:
25% (14°)
Maximum side slope rating:
25% (14°)
Note: Slope rating is subject to ground conditions
with one person in the platform and adequate
traction. Additional platform weight may reduce
slope rating. The term gradeability applies to the
counterweight uphill configuration only.
Be sure the boom is below horizontal and the
platform is between the circle-end wheels.
Move the drive speed select switch to machine on
incline symbol.
To determine the slope grade:
Measure the slope with a digital inclinometer OR
use the following procedure.
You will need:
carpenter’s level
straight piece of wood, at least 3 feet/1 m long
tape measure
Lay the piece of wood on the slope.
At the downhill end, lay the level on the top edge of
the piece of wood and lift the end until the piece of
wood is level.
While holding the piece of wood level, measure the
vertical distance from the bottom of the piece of
wood to the ground.
Divide the tape measure distance (rise) by the
length of the piece of wood (run) and multiply by
100.
Example:
Piece of wood = 144 inches (3.6 m)
Run = 144 inches (3.6 m)
Rise = 12 inches (0.3 m)
12 in ÷ 144 in = 0.083 x 100 = 8.3% grade
0.3 m ÷ 3.6 m = 0.083 x 100 = 8.3% grade
If the slope exceeds the maximum slope or side
slope rating, then the machine must be winched or
transported up or down the slope. See Transport
and Lifting section.
Содержание Genie Z-45XC
Страница 11: ...First Edition First Printing Operator s Manual General Safety Part No 1301594GT Z 45 XC 9 ...
Страница 26: ...Operator s Manual First Edition First Printing Controls 24 Z 45 XC Part No 1301594GT Platform Control Panel ...
Страница 27: ...First Edition First Printing Operator s Manual Controls Part No 1301594GT Z 45 XC 25 ...
Страница 60: ......