Terex Genie Z-45XC, Руководство оператора

Страница: 38 / 60

Operator's Manual First Edition • First Printing
Inspections
36 Z
®
-45 XC
™
Part No. 1301594GT
56 Return to level ground and raise the secondary
boom to an out of stowed position
(approximately 15° above horizontal).
57 Drive the machine onto a slope where the
chassis pitch angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
58 Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
59 With the boom fully stowed, drive the machine
onto a slope where the chassis pitch angle is
greater than 4.5°.
Result: The machine should continue to drive.
60 Return to level ground and raise the primary
boom to an out of stowed position
(approximately 10° above horizontal).
61 Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
62 Lower the primary boom to the stowed position
or drive in the opposite direction.
Result: The machine should drive.
63 Return to level ground and extend the primary
boom approximately 1.6 ft / 0.5 m.
64 Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
65 Retract the primary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
66 Return to level ground and stow the boom.
67 With the boom fully stowed, drive the machine
onto a slope where the chassis roll angle is
greater than 4.5°.
Result: The machine should continue to drive.
68 Return to level ground and raise the secondary
boom to an out of stowed position
(approximately 15° above horizontal).
69 Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
70 Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
Test the Oscillating Axle
71 Drive the right steer tire up onto a 6 in/15 cm
block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
72 Drive the left steer tire up onto a 6 in/15 cm
block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
73 Drive both steer tires up onto a 6 in/15 cm
block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.