72 GTH-4016SR • GTH-4018SR Part No. 57.4400.9203
March 2010
Section 5 • Settings
REV A
How to Set the Overload Warning
System
1. Start the engine.
2. Stabilize the machine on a level ground.
3. Align the turret to the chassis.
4. Insert the turret locking pin.
5. Turn off the engine
6. Start the engine again.
7. Press “ENTER” and then simultaneously press
the two buttons PLUS (+) and MINUS (-) up to
the request of password.
8. To dial the password (contact the Service),
keep in mind that pressing button PLUS (+)
figures increase and pressing button MINUS
(-) figures decrease.
9. Conferm each figure pressing “ENTER”
10. Once the password has been completed, the
writing “2
nd
LEVEL ACCESS” appears.
11. Keep the button PLUS (+) pressed to make
the setting options appear.
12. Language
13. ENTER
14. Once entered, use ARROW UP or ARROW
DOWN pushbuttons to select the language
15. ENTER
16. By using PLUS (+) and MINUS (-)
pushbuttons, select “SAVE”
17. ENTER
18. By using PLUS (+) and MINUS (-)
pushbuttons, select “EXIT”
19. ENTER
20. By using ARROW UP or ARROW DOWN
pushbuttons, select “LENGHT”
21. Completly retract the boom.
SETTINGS
22. ENTER
23. By using PLUS (+) and MINUS (-)
pushbuttons, select “MIN”
24. ENTER
25. By using PLUS (+) and MINUS (-)
pushbuttons, select “SAVE”
26. ENTER
27. Completly extend the boom.
28. By using PLUS (+) and MINUS (-)
pushbuttons, select “MAX”
29. ENTER
30. By using PLUS (+) and MINUS (-)
pushbuttons, select “SAVE”
31. ENTER
32. By using PLUS (+) and MINUS (-)
pushbuttons, select “EXIT”
33. ENTER
34. By using ARROW UP or ARROW DOWN
pushbuttons, select “ANGLE”
35. ENTER
36. Put the boom in horizontal position helping
you by a tilt device.
37. By using PLUS (+) and MINUS (-)
pushbuttons, select “ZERO”
38. ENTER
39. By using PLUS (+) and MINUS (-)
pushbuttons, select “SAVE”
40. ENTER
41. By using PLUS (+) and MINUS (-)
pushbuttons, select “EXIT”
42. ENTER
43. TILT SENSOR (if present)
44. ENTER
Содержание Genie GTH4016 SR
Страница 4: ...iv GTH 4016SR GTH 4018SR Part No 57 4400 9203 March 2010 Intentionally blank page ...
Страница 12: ...xii GTH 4016SR GTH 4018SR Part No 57 4400 9203 March 2010 Intentionally blank page ...
Страница 92: ...80 GTH 4016SR GTH 4018SR Part No 57 4400 9203 March 2010 Section 5 Settings REV A Intentionally blank page ...
Страница 124: ......