Terex Genie GTH-1256, Руководство по обслуживанию и ремонту

Страница: 82 / 136

4-12 GTH-1256 Part No. 1272856
September 2016 Section 4 • Fault Codes
3241 0 Sensor SCR catalyst upstream temperature too high; plausibility error
3241 1 Sensor SCR catalyst upstream temperature too low; plausibility error
3361 7 AdBlue dosing valve blocked (SCR)
523720 2 Sensor urea supply module heater temperature; plausibility error (normal condition)
523720 2 Sensor urea supply module heater temperature; plausibility error (cold start condition)
523721 2 Sesnor urea supply module temperature; plausibility error (normal condition)
523721 2 Sensor urea supply module temperature; plausibility error (cold start condition)
523981 11 Urea-tank without heating function (heating phase)
523330 14 Immobilizer status; fuel blocked
523720 8 Urea supply module heater temperature; duty cycle in failure range
523720 8 Urea supply module heater temperature; duty cycle in invalid range
523721 11 Urea supply module temperature measurement not available
523722 8 Urea supply module PWM signal; period outside valid range
523722 8 Detect faulty PWM signal from Supply Modul
523721 8 Urea supply module temperature; duty cycle in failure range
523721 8 Urea supply module temperature; duty cycle in invalid range
29 3 Handthrottle idle validation switch; short circuit to battery
91 8 Accelerator pedal duty cycle PWM signal; signal range check high
91 8 Acceleration pedal cycle duration PWM signal; signal range check high
91 3 Sensor error accelerator pedal; signal range check high
29 3 Sesnor error handthrottle; signal range check high
29 4 Handthrottle idle validation switch; short circuit to ground
91 8 Accelerator pedal dutycycle PWM signal; signal range check low
91 8 Acceleration pedal cycle duration PWM signal; signal range check low
91 4 Sensor error accelerator pedal; signal range check low
29 4 Sensor error handthrottle sensor; signal range check low
523921 3 Sensor error burner temperature; signal range check high
3532 3 Sensor error urea tank level; signal range check high
523921 4 Sensor error burner temperature; signal range check low
3532 4 Sensor error urea tank level; signal range check low
1079 13 Sensor supply voltage monitor 1 error (ECU)
1080 13 Sensor supply voltage monitor 2 error (ECU)
523601 13 Sensor supply voltage monitor 3 error (ECU)
677 3 Starter relay high side; short circuit to battery
677 4 Starter relay high side; short circuit to ground
677 5 Starter relay; no load error
FAULT CODES