Terex Genie GS-1530, Руководство по обслуживанию, Страница: 67 / 198

Section 4 • Repair Procedures June 2009
Part No. 96316 GS-30 • GS-32 • GS-46 4 - 13
REV D PLATFORM CONTROLS
How to Change the
Software Configuration
1 Pull out the red Emergency Stop button to the
on position at the ground controls.
2 Push in the red Emergency Stop button to the
off position at the platform controls.
3 Turn the key switch to platform control.
4 At the platform controls, press and hold the lift
function select and speed select buttons, and
pull out the red Emergency Stop button to the
on position.
Result: The diagnostic display, at the platform
controls and the ECM, will show "SC."
5 Release the lift function select and speed select
buttons.
Result: The diagnostic display will show the
current configuration.
6 Press the lift function select button.
Result: The 'tens' digit setting will be activated
and the current 'tens' setting will flash in the
diagnostic display. Use the steering thumb
rocker switch on the joystick to increase or
decrease the value. See 1-4,
Machine
Configuration Code Chart for configuration
settings.
7 Press and hold the lift function select button for
a minimum of 3 seconds to set the 'tens' value.
a joystick controller JC1 with thumb
steering rocker SW6
b lift function select button BN9
c diagnostic display
d red Emergency Stop button P2
e drive function select button BN8
f speed select button BN6
8 Press the speed select button.
Result: The 'ones' digit setting will be activated
and the current 'ones' setting will flash in the
diagnostic display. Use the steering thumb
rocker switch on the joystick to increase or
decrease the value. See 1-4,
Machine
Configuration Code Chart for configuration
settings.
9 Press and hold the speed select button for a
minimum of 3 seconds to set the 'ones' value.
10 Turn the key switch to the off position.
Note: Any change in software settings will not take
effect until the key switch is turned to the off
position.
a
e
b
f
d
c