Operator's Manual
First Edition • First Printing
26
AL4000 • AL5000
Part No. 116416
Operating Instructions
11 Press the program button (P) to set the timer for
the desired shut-off time. AM 12:00 will appear
in the display with a small 2 to the right. The
lamp symbol will not appear above the 2.
12 Use the day, hour and minute buttons to set the
timer to the desired shut-off day and time.
13 Move the set switch to
RUN
.
Photocell (machines with auto start option)
Note: Lockout the machine when auto start is
turned on
When the photocell is turned on, the lights will go
on at dusk and go off at daylight. The engine will
automatically start prior to the lights going on.
When the photocell option is in use and the
photocell has detected a low enough light level to
start the light tower, the engine running light on the
LED panel will flash for 30 seconds before the
engine starts.
To turn on the photocell:
1 Move the engine start switch to timed
start.
2 Move the photocell switch to on.
Operation of Tower
1 Remove the tower travel lock pin from the cradle
located on the rear of the cabinet.
2 Remove the tower locking pin from the tower
base.
3 Using the pivot winch, raise the tower to the
vertical position.
4 Reinsert the tower locking pin into the tower
base.
Manual Operation of Lights
Note: The engine must be running before the lights
are turned on.
1 Turn on the main circuit breaker switches on the
control panel.
2 Turn on the lights using the individual light
switches.
3 Turn the lights off by flipping the individual light
switches to the off position. Make sure the
lights are turned off before shutting down the
engine.
Grounding
A grounding rod is located inside the door on the
road side of the machine.
Drive the rod into the ground and
connect it to the grounding lug
located on the chassis near the base
of the tower.
Electrical Outlets (if
equipped)
Electrical outlets are located on the control panel
inside the enclosure on the road side of the light
tower cabinet.
