Terbly PT330W-R, Руководство пользователя

Страница: 36 / 40

PT330W-R User Manual XM1147-V1.0-NR
35
Cyan Color wheel Er
(Cyan Color wheel- error) This message will appear after the reset of the fixture if the head’s
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the stepper motor is
defective (or its driving IC on the main PCB)
.
The CMY - movement is not located in the default
position after the reset
.
Magenta Color wheel Er
(Magenta Color wheel- error) This message will appear after the reset of the fixture if the head’s
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the stepper motor is
defective (or its driving IC on the main PCB)
.
The CMY - movement is not located in the default
position after the reset
.
Yellow Color wheel Er
(Yellow Color wheel- error) This message will appear after the reset of the fixture if the head’s
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the stepper motor is
defective (or its driving IC on the main PCB)
.
The CMY - movement is not located in the default
position after the reset
.
13. CLEANING AND MAINTENANCE
The following points have to be considered during inspection
1) All screws for installing the devices or parts of the device have to be tightly connected and
must not be corroded
.
2) There must not be any deformations to the housing lenses rigging and installation points
(ceiling suspension trussing)
.
3) Motorized parts must not show any signs of wear and must move smoothly without issue
.
4) The power supply cables must not show any damage material fatigue or sediment
.
Further instructions depending on the installation location and usage have to be adhered to by a
qualified installer and any safety concerns have to be removed
.
In order to ensure the device remains in good condition and does not fail prematurely we suggest
regular maintenance
.
1) Clean the inside and outside lens each week to avoid loss of output due to accumulation of
dust/ dirt on the lens
.
2) Clean the fans each week to ensure maximum airflow and efficient thermal cooling
.
This will
ensure the light source is operated in the best possible condition
.
3) A detailed electrical check by an approved electrician every quarter to make sure that the
circuit contacts are in good condition
.
This will prevent poor circuit contacts and the resultant
overheating
.