Terbly PT330W-R, Руководство пользователя

Страница: 15 / 40

PT330W-R User Manual XM1147-V1.0-NR
14
8. DEVICE DMX START ADDRESS SELECTION
All fixtures should be given a DMX starting address when using a DMX signal so that the
correct fixture responds to the correct control signals
.
This digital starting address is the channel
number from which the fixture starts to
“
listen
”
to the digital control information sent out from the
DMX controller
.
The allocation of this starting address is achieved by setting the correct address
number on the display located on the base of the device
.
You can set the same starting address for all fixtures or a group of fixtures or set different
addresses for each fixture individually
.
If you set the same address on all devices all the devices will start to
“
listen
”
to the same control
signal from the same channel number
.
In other words changing the settings of one channel will
affect all the fixtures simultaneously
.
If you set a different address each unit will start to
“
listen
”
to the channel number you have set
based on the quantity of control channels of the unit
.
That means changing the settings of one
channel will affect only the selected device
.
In the case of the PT330W-R in 19 channel mode you should set the starting address of the first
unit to 1
the second unit to 20 (19 + 1) the third unit to 39 (19+ 20) and so on
.
9. OPERTING INSTRUCTIONS OF THE INTERNAL DMX WIRELESS
SYSTEM
1
.
Equipments
DMX 512 controller wireless transmitter and the fixtures with wireless receiver
.
2
.
Message from the LED indicator
1) Rapid flashing red/Green logging in to a transmitter
2) Slow flashing Red/Green Logged on a transmitter and the DMX line is idle (No DMX is
connected to transmitter)
.
3) Solid Green Logged on to a transmitter and receiving DMX data
.
4) Solid Red Not logged on to a transmitter (free)
.
3 WDMX in the menu of the fixture
On a fixture installed with wireless system in order to switch between wireless control
system and traditional DMX control (with cable) a new menu WDMX is added to the display
board
.
ON (Activate WDMX)
1) When the fixture is on power and the WDMX is activated to ON status but did not
connect to the controller and did not log in to the transmitter the fixture will search for the DMX
signal source
.
If the fixture is connected to the DMX controller it can be controlled by DMX
controller if it is log in to the wireless transmitter it can be controlled by the Transmitter
.
2) When the fixture is power off and the WDMX is in ON status if the fixture is connected
to DMX controller
.
After the fixture is power on it can be controlled only by the DMX controller
which connected
.
The fixture can log in the wireless transmitter and receive only radio signal
from transmitter but not DMX from the transmitter
.
OFF (De-activate WDMX)
In this status wireless system is not activated so the fixture can not log in the transmitter
.