If the timer should be turned off, immediately appears at the display:
>2.0xE12W T=OFF
* mathematical representation of technical representation < 2TW
* * Alternating to the timer display T=OFF is shown the measure voltage mode: Auto, 100V or 10V
To turn off the appliance press again key B .
In the battery mode the unit turns off , if no button was pressed, automatically after approximately 5 minutes.
2.2 Charging the NiMH Battery
The TOM 600 allowed only to operating directly with the enclosed power supply. Also only with these the
installed NiMH
–
batteries can be charged. Connect the power supply to the integrated socket, and connect
the plug power supply to a power socket. If the appliance is switched off, and the charging work correct, the
green Charge LED shines.
The NiMH - batteries are completly charged after maximum of 14 hours and good for > 10 hours
continuous operation. A longer charging time can dammage the batteries.
2.3 Measure Range and Measure Voltage
The TOM 600 has an automatic ranging approve the whole resistor range. The appliance, accordingly the
measure resistance, selects the Measure voltage automatically.
l
Measured resistance less then 200 kW
—
- Measure Voltage 10 VDC
l
Measured resistance more then 200 kW
—
- Measure Voltage 100 VDC
In the Set-Up this automation can be switched off, and a constant measure voltage can be select.
The measure ranges are than as following :
l
Measure voltage 10V -- measure range 20kW .... 200GW
l
Measure voltage 100V -- measure range 100kW .... 2TW
3
