5. Connect the charger’s DC cord into the machine’s
battery charge receptacle (Figure 41).
FIG. 41
6. The supplied charger will automatically begin
charging and shut off when fully charged.
NOTE:
The machine will not operate when charging.
ATTENTION: Do not disconnect the charger’s DC
cord from the machine’s receptacle when the
charger is operating. Arcing may result. If the
charger must be interrupted during charging,
disconnect the AC power supply cord first.
MACHINE MAINTENANCE
To keep the machine in good working condition,
perform the following maintenance procedures.
FOR SAFETY: Before leaving or servicing machine,
stop on a level surface and turn off machine.
WARNING: Electrical Hazard. Disconnect
Battery Cables Before Servicing Machine.
ATTENTION: Contact an authorized service center
for machine repairs. Machine repairs performed by
other than an authorized person will void your
warranty.
AFTER EVERY USE
1. Drain and rinse out the recovery tank (Figure 42).
FIG. 42
2. Rinse off the recovery tank float sensor
(Figure 43).
FIG. 43
3. Clean the vacuum fan filter with low water pressure
(Figure 44). Allow the filter to completely dry before
reinstalling.
FIG. 44
8
R14 1032129 REV.01 (12-06)
