IB 340857 (03--2007)
1
INSTRUCTION BULLETIN
No. 340857
Machine: M20 / T20
Published: 03--2007
Rev. 00
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual parts and will save the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for
kit number 9003489
SYNOPSIS:
This kit contains the parts needed to install a strobe light/alarm kit on M20 and T20 machines.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 1.5 hours)
PREPARATION:
1. Park the machine on a clean level surface, turn
off the machine, remove the key, and set the
parking brake.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, set parking
brake, turn off machine, and remove key.
2. Open the front shroud and the engine shroud.
3. Disconnect the negative terminal and then the
positive terminal from the battery.
WARNING: Always disconnect battery
cables from machine before working on
electrical components.
NOTE
:
If installing the strobe light (13) onto the
bracket (5), proceed to the instructions beginning
on this page. If installing the strobe light (13) onto
the overhead guard, proceed to the instructions
starting on page 6.
INSTALLATION: (w/strobe light (13) installed
onto bracket (5))
1. Use two hex screws (2), two flat washers (3),
and two hex nuts (4) to install the backup
alarm (1) onto the bracket (5). Refer to Fig. 1.
1
2
3
4
5
FIG. 1