Tennant 8010, Руководство оператора

Страница: 86 / 106

MAINTENANCE
8010 330100 (3--98)
84
REPLACING THE MAIN SWEEPING BRUSH
(For machines serial number 000129 and above.)
1. Raise the sweeping assembly.
2. Turn the machine power off and set the
parking brake.
FOR SAFETY: Before leaving or
servicing machine; stop on level
surface, set parking brake, turn off
machine and remove key.
3. Remove the hardware and lift open the left
side main brush door.
4. Remove the hardware mounting the brush
idler plate to brush arm.
5. Pull the idler plate off the brush.
6. Line up the drive end of the new brush with
the drive plug.
7. Install the idler plate to the brush arm with
the mounting hardware.
8. Check the brush pattern as described in
CHECKING AND ADJUSTING THE
SWEEPING MAIN BRUSH PATTERN.
9. Close and latch the main brush door.
CHECKING AND ADJUSTING THE MAIN
SWEEPING BRUSH PATTERN (For machines
serial number 000128 and below.)
1. Apply chalk, or some other material that will
not blow away easily, to a smooth, level
floor.
2. Turn the machine on. With the sweeping
assembly raised, position the sweeping
assembly over the chalked area.
3. With a foot on the brake to keep the
machine from moving, lower the sweeping
assembly to the floor for 15 to 20 seconds.
Raise the sweeping assembly and back the
machine away from the test area.
NOTE: If no chalk or other material is available,
allow the brush to spin on the floor for two
minutes.