Snappi System User Manual
Document No: 053-05 v38
Page 48 of 76
June 2022
Snappi System User Manual.doc
•
Always ensure both the sun hood and rainshield are dry before folding for storage.
Do not put either of these items near a heat source as this will damage the material.
In addition, please make sure you do not store the rainshield in direct sunlight as
the heat may melt the adhesive. Both items can be wiped clean using a damp
cloth.
•
The sunhood and rainshield must be removed when folding the wheelbase.
•
The sunhood and rain shield must be removed when using the pushchair in a
wheelchair adapted vehicle. Full transport instructions can be found in your Snappi
User Manual.
•
Although the sunhood is made of showerproof black fabric, it is still necessary to
use the transparent rainshield to protect the occupant from the rain.
•
If you remove the screws from the hood for any reason, please ensure that you
screw them back on to the hood through the hole in the fabric. Do not try to stretch
the hole over the screw as you may damage the material.
•
Always check that the thumb screws are tight to prevent them from falling off.
6.4b: Removing the cover for washing:
These instructions apply to both type of sunhood fixings.
Fig 6.4c.1
Remove the sun hood from the pushchair,
and place on a flat surface.
Undo the Hook & loop loops securing the
sun hood to the mounting bars as shown
(see Fig 6.4c.1).
Next, unscrew the 2 thumbwheels securing
the angle adjustors on both sides (see fig
6.4c.2).
Fig 6.4c.2
