Snappi System User Manual
Document No: 053-05 v38
Page 12 of 76
June 2022
Snappi System User Manual.doc
4.1.2 Unfolding the Frame (Spring loaded locks)
Standing at back of the wheelbase, place
your foot on the rear cross member X
(see Fig 4.1.2.1) and lift handle labelled
Y as far as it will move.
This will open the frame.
Fig 4.1.2.1
Fig 4.1.2.2
Once the frame is almost open, the 2 plastic
frame locks will engage with the angled
sections of the lower frame.
Continue to unfold the frame; this will force
the locks up the tubes. There will be some
resistance, as you will be working against the
locking springs.
Once fully open, the frame locks will snap
shut over the front frame, securing the
frame in the open position.
Always check that both locks are fully
closed. In the locked position the guide
bolt ‘
B
’ will be sat in the top of the slot ‘
A
’
on the side of the slider as shown (see
Fig 4.1.2.3). If there is any slot visible
above the guide bolt, push the lock down
by hand until it will not move any further.
Fig 4.1.2.3
Fig 4.1.2.4
To fold the frame:
Standing beside the frame, pull up the 2
locking sliders as shown (see Fig 4.1.2.4).
Whilst holding the locks open, push down
with your arm on the upper frame or push
handle, so that the frame starts to fold.
Release the locking sliders, and fold down
the frame by moving the push handle down
as far as it will move.
