Ten-Haaft samy solar plus, Руководство по эксплуатации

Страница: 63 / 128

63
E
Manual search
The manual search is usually used to fi ne-tune the antenna to a found satellite un-
der adverse reception conditions. If you wish to receive signals from a new satellite
that is not yet stored as a search satellite in the control unit, the manual search
function can be used to tune the system to this satellite.
Firstly, switch your receiver to a pre-programmed station that is transmitted by the
desired satellite.
At the control panel, press until the message „Manual search“ appears in the
display. After pressing , use the arrow keys to change the position of the antenna
in increments. First, the pivot angle needs to be adjusted. To change between the
pivot angle and the elevation angle, press and hold and
at the same time press
one of the arrow keys.
Using the arrow keys, adjust the system around both axes to the strongest receivab-
le signal. For further information on the signal level please refer to the manual of
your satellite receiver.
After having set the antenna to an optimal reception, you can store this position for
the current location by pressing again.
The stored position will then be resumed the next time the system is switched back
on. Even if no satellite signal is received in this position, the automatic search will
not be started if you have stored a manually set position before. If you wish to carry
out an automatic search, start it via the general menu.
If the „Manual search“ is cancelled by pressing , the current position is not
stored. The system returns to the default position.